I purchased an used GAP Pre-73 DLX to increase my mic preamp capacity.
The manual is very minimal and doesn’t give any instruction for the use of the switchable 600 ohm output termination .
I tried to find the answer in the net forum, but couldn’t find any straight answer.
The question is, should this 600 ohm output termination be activated or not - and the reasoning for that/what does this do in practice.
The use case here is mic pre before the KT-2A, mainy vocal. Mic is Neumann, condenser.
The manual is very minimal and doesn’t give any instruction for the use of the switchable 600 ohm output termination .
I tried to find the answer in the net forum, but couldn’t find any straight answer.
The question is, should this 600 ohm output termination be activated or not - and the reasoning for that/what does this do in practice.
The use case here is mic pre before the KT-2A, mainy vocal. Mic is Neumann, condenser.
Statistics: Posted by Harry_HH — Fri Jul 19, 2024 7:26 am — Replies 2 — Views 59